PSX Installation Manual (PSX-1 and PSX-2) ver. 1.1
Trouble Shooting:
No connectivity
Check to make sure the blue “power on” indicator light on the front
panel is lit. If the light is not lit, verify that the 12Volt AC power supply is
plugged into an un-switched AC outlet and the outlet is providing power.
Check to make sure that the home network is connected and working.
An Ethernet cable is plugged into the back panel of the PSX. There are two
indicator lights on the Ethernet jack; a solid green light indicates the PSX is
connected to the home network, a flashing amber light indicates network
traffic to and from the dock. If green light is not lit, check to see that the
home network router /switch connected to the PSX is powered on and
working.
Check to make sure the MX-6000 remote has not lost the Wi-Fi signal.
If the MX-6000 remote control has lost the Wi-Fi signal it will automatically
try to reconnect to the Wi-Fi network in five seconds.
If an iPod in the PSX is getting synced to iTunes on a network
computer it will not be available for use until it has been disconnected
from iTunes using the URC PSXLink software tool.
PSX appears to have locked up
Remove the iPod from the PSX, wait two seconds, then place it back in
the dock. Make sure the iPod has not locked up. If it has, you will need to
reset it. Follow the manufacturer’s instructions on resetting the iPod. When
placed back in the dock, the Universal Remote Control “connected” splash
screen should appear on the iPod.
If the URC splash screen does not appear, remove the iPod from the
dock, reach around to the back of the PSX and press the “Reset”
button, located on the far right side of the back panel, next to the
12Volt power plug.
The PSX will reset and resume operation after approximately five seconds.
Place the iPod back in the dock. The Universal Remote Control “connected”
splash screen should appear on the iPod and the PSX will resume normal
operation.
Restoring Factory Default Settings
Press and hold the “Reset” switch for ten seconds. Release the reset
button. The PSX will be reset to the factory default setting. Use the URC
PSXLink software tool to rename the dock and reconfigure the video output
setting. Right click on the dock in the PSXLink window. Click on “Check
Settings”. Internet Explorer will open up and you will see the Web-based
configuration interface. Click on the configuration tab. Enter a new dock
name, select the appropriate video output mode, then click on the
submit button. The information will be transmitted to the PSX and you will
see a confirmation screen on the web interface.
(16 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais