Universal Remote Control MX-5000 Guia do Utilizador descarregar pdf (Página 54)

Learning a Batch of Buttons Efficiently

Tip - Find the correct “learning distance” using single code learning before doing

Batch Learning.

beginning batch learning.

1 Select the Starting Button - Select the button that is the top left of the buttons you want to teach to.

When learning a batch of hard buttons, CCP starts at the VOL Up, moves down the hard buttons on

the left, then goes to the top right hard button. When learning soft buttons, CCP starts at the top left,

moves across each row, then moves down.

2 Select the “Next Button” icon before you press “Learn” - This button activates the Batch Learning

mode of CCP.

3 Watch the LEARNING Window - When the info window says “Learn Ready”, press and hold the

button on the original remote control. When it says “Learn OK”, release the button. During “Batch

Learning”, the CCP automatically “Saves” the IR command and then selects the next button to learn.

When you see that a new button has been selected and the Learning window says “Learn Ready”,

then press and hold the corresponding button on the original remote control. Batch Learning greatly

speeds up the learning process.

Tip - To skip a button in the automatic sequence, simply click on the “Skip” button.

4 Press “Cancel” to stop / exit the Batch Learning session.

Type in Section Title

IR Learning

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 90 91

Sem comentários

Universal Remote Control MX-5000 Guia do Utilizador Página 54