Universal Remote Control R7 - SPECS SHEET Manual do Utilizador descarregar pdf (Página 28)

S3F80KB_AN_REV 0.00 (Preliminary Spec) IR REMOTE CONTROLLER

4 TEST METHOD

MCU MCU

Test board 1

Test board 2

Figure 10. Application Concept Diagram

4.1 IR TEST METHOD

1. Place two remote controllers to front each other

2. Configure test board 1 to transmission mode.

• The initial mode is transmission mode after reset.

• At the end of the learning mode, mode is go into transmission mode.

3. Configure test board 2 to reception mode.

• Press Key(SW2 ~SW5) and next press key(SW6~17) to store IR data code

4. Press Key(Sw6 ~ Sw17) of the signal which want to transmit

5. Check 7-segment to confirm the transmission and reception is completed

• To confirm, check test board 1 and test board 2's word displayed in 7-segment. If test board 1 and test

board 2's word is same, it's normal, otherwise it's abnormal. Check test board 2 displayed word in 7-

segment after press the key stored data code. If test board 1 and test board 2's word is same, it's normal,

otherwise it's abnormal.

1 2 ... 23 24 25 26 27 28 29 30 31

Sem comentários

Universal Remote Control R7 - SPECS SHEET Manual do Utilizador Página 28