Universal Remote Control TOTAL CONTROL FX-1 Manual do Utilizador descarregar pdf (Página 2)

Congratulations! Your Universal Remote Control (URC) is a state-of-the-art

device which integrates many different infra-red remote controls to deliver

instant A/V action to your fingertips.

Before operating the remote, please read thoroughly (1) the interior of the

coversheet and (2) this manual. Then reserve them for future reference.

1 HOW TO INSTALL BATTERIES

Alkaline batteries recommended. The number of battery required stated at

the back of the coversheet.

1. Remove the battery cover on the back of your URC.

2. Observe the polarity of the batteries and the “+/–” marks inside the battery

compartment.

3. Insert the batteries.

4. Push the battery cover back in place.

Battery Low

If the indicator flashes twice slowly after your invoking of any command, it

shows that the battery level is low. You must replace them with new batteries

to ensure proper functioning.

2 HOW TO SET UP THE URC

By entering Device Code

You may setup the URC by the following code entering instructions.

1. Refer to the DEVICE CODE LIST, look up the 4-digit Device Code which

corresponds to the brands of your A/V equipment. If there are more than

one Device Code listed under your brand, try from the first code.

2. Press a desired Device Mode Key (e.g. ).

3. Hold down “ P+ ” and “ VOL– ”on the URC together simultaneously for 2

seconds until the indicator lights up.

4. Use the number keys to enter your 4-digit Device Code, the indi-

cator should go out immediately.

Turn on your device (e.g. TV), try the function keys on the URC. If your device

(e.g. TV) responds to your invoked function correctly, you have entered the

right Device Code. Otherwise, repeat the above setup instructions with the

rest available Device Codes until your device (e.g. TV) responds to your in-

voked function, and most keys work correctly.

* Simply repeat the above procedures to enter the Device Codes for your

VCR, SAT, DVD or CTV. (Remember to press a correct Device Mode Key

in step 2 above)

English

Note :

– DVD, CTV and other Device Codes can be entered into any device modes

except “TV” & “VCR” modes. Just simply press the device mode key

and enter your 4-digit device code for DVD, CTV and other devices.

If the indicator flashes twice in step 4, a wrong Device Code has been

entered. You are required to repeat step 2 to 4 again.

Suggestion :

– If you cannot find a correct Device Code for your equipment, see 2 HOW

TO SET UP THE URC– By Seaching Through the Library.

– You are recommended to jot down your Device Codes in the space provided

on back label after setting up the URC correctly for future reference.

1 2 3 4 5 6 7 ... 25 26

Comentários a estes Manuais

Sem comentários

Universal Remote Control TOTAL CONTROL FX-1 Manual do Utilizador Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com Controlos remotos Universal Remote Control TOTAL CONTROL FX-1