Universal Remote Control URC-4041 Manual do Utilizador descarregar pdf (Página 10)

URC PLUS User’s Guide



3. Select the decoder to register by:

 Press “1” to register URC PLUS to decoder 1.

 Press “2” to register URC PLUS to decoder 2.

 Press “3” to register URC PLUS to decoder 3.

After you enter a registration event, the “STB” button backlight on the URC PLUS will blink twice to

indicate that the registration process was successful.

The Hydra front panel will display “RC REG Dx” to indicate that the registration process was successful.

Figure 2-9 Remote Registration Successful

Pressing a key other than “0”, “1”, “2”, “3” or a button is not pressed within 10 seconds, the “STB”

backlight will extinguish and the URC PLUS registration process will be terminated.

4. If the Hydra does not receive any URC PLUS registration event within 30 seconds, the process will be

terminated.

The Hydra front panel displays the following messages during remote control registration:

Front Panel Message

Description

RC REG TO Registration times out

RC REGERR Registration error

RC REG In registration mode

RC REGEND Registered to IR only mode

RC REG D1 Registered to decoder 1

RC REG D2 Registered to decoder 2

RC REG D3 Registered to decoder 3

Table 2-1 Remote Registration Messages

NOTE:

 While the URC PLUS is in “STB” mode, the volume +/- and MUTE key signal will be sent to the TV.

 While the URC PLUS is in “STB” mode, the POWER key signal will be sent to both the STB and the

programmed TV.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sem comentários

Universal Remote Control URC-4041 Manual do Utilizador Página 10