Universal Remote Control WC-1 Manual de Instalação descarregar pdf (Página 23)

7.3 Terminal Commands

The following is a summary of the Terminal Commands supported by the WC 1:

COMMAND PARAMETER DESCRIPTION RANGE UNITS

V1 Prepurge time 0-650.00 .01Sec.

V2 Arc start current 0-500 Amps

V3 Arc Start Wire feed speed 0-650 Ipm

V4 Arc Start delay time 0-650.00 .01 Sec.

V5 Ramp up Delay time 0-650.00 .01 Sec

V6 Run time current (Pulse Peak current) 0-650.00 Amps

V7 Run Time wire feed speed 0-650 Ipm

V8 Spot Weld Time (If Time=0 then Manual control) 0-650.00 .01 Sec.

V9 Percent Taper current 0-100 %

V10 Taper current delay time 0-650.00 .01 Sec.

V11 Ramp down delay time 0-650.00 .01 Sec.

V12 End current value 0-500 Amps

V13 End wire feed speed 0-650 Ipm

V14 End delay time 0-650.00 .01 Sec.

V15 Reverse wire speed time delay 0-650.00 Sec.

V16 Wire burn back delay time 0-650.00 .01 Sec.

V17 Post gas flow time delay 0-650.00 .01 Sec.

V18 Pulse current on time .001 – 65.000 .001 Sec.

V19 Pulse current off time .001 – 65.000 .001 Sec.

V20 Percent back ground current 0-100 %

V21 Jog wire feed speed 0-650 Ipm

Table 7 - Weld Process and Command Table

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Sem comentários

Universal Remote Control WC-1 Manual de Instalação Página 23